— Experimental Blueprint —
A copper pyramid mounted on a self-orienting pontoon platform, coupling the pyramid's electromagnetic geometry directly to open water instead of a grounded earth rod.
Theoretical & experimental device, extending the Pyramid Blueprint to a floating water context. Not yet peer-reviewed at scale.
Octagonal pontoon ring — 2x the pyramid base width for stability
Sealed foam-filled floats wrapped in thin copper mesh for water-field coupling
Standard Stage I copper pyramid, golden ratio to height (φ = 1.618)
Replaces the earth rod — suspended 0.5 m below the waterline as the water-coupled ground
Sealed in waterproof housings at each pontoon strut and the apex
Slack mooring lines allow the platform to self-align with water current and wind
Height of pontoon above waterline — keeps the copper base dry and oxidation-free
Pyramid face aligned true north; platform drifts back into alignment via mooring geometry
Build an octagonal ring of 8 sealed HDPE pontoons wrapped in thin copper mesh. Bolt them into a rigid frame that can support the pyramid's weight plus a person seated at the King's Chamber point.
Centre the standard Stage I copper pyramid on the pontoon frame, bolted through reinforced deck plates. The pyramid apex and base crystals are wired exactly as the land-based design.
Hang a 0.9 m copper disc 0.5 m below the waterline directly under the pyramid centre, connected via 6 AWG copper wire. Water replaces earth as the grounding and field-coupling medium.
Anchor the platform with slack mooring lines at four corners so it can drift and self-orient with wind and current, while a compass check keeps one face oriented to magnetic north.
Lower the platform onto the water and check freeboard is even on all sides. Adjust pontoon ballast until the pyramid sits level and the King's Chamber seating position is stable.
Sit at the King's Chamber point (1/3 height) as with the land version. The water beneath the platform acts as a structured, moving conductor — continuously refreshing the field coupling instead of a static grounded rod.
Righting margin (%) vs induced roll angle across increasing wave conditions
The pontoon ring maintains a positive righting margin through moderate sea states, with roll angle staying under 10° up to 1.2m swell — beyond which mooring tension should be shortened.
Relative SEG field output (%) and water depth (m) across placement zones
Output peaks in open water placements where the submerged ground plate couples to a larger, less turbulent conductive volume, tapering slightly in very deep offshore zones.
Effects of the platform are localised and short-range — the summary below outlines expected impact zones around the installation.
The submerged copper ground plate and slow-moving pontoon shadow create a small artificial reef effect, attracting fish and encrusting organisms within a ~5-10 m radius. Copper is mildly biocidal at direct contact, so the plate housing is sealed to prevent leaching into open water.
Structured (EZ) water effects around the ground plate are expected to extend roughly 3-8 m outward before dissipating into ambient turbulence — a localised zone, not a wide-area change. No measurable shift in pH, salinity, or dissolved oxygen is expected beyond this near-field radius.
The pyramid's field is strongest within its own base perimeter and falls off sharply with distance, with only a faint, non-disruptive presence detectable 15-20 m out. This is well below any threshold known to affect fish navigation or marine mammal sonar.
The 4-point mooring anchors disturb only their immediate contact points on the seabed. Slack mooring lines avoid dragging across the bottom, and anchor placement should avoid seagrass beds or coral to prevent physical damage during installation.
Unlike a static earth rod, flowing or open water is in constant motion, continuously exchanging ions with the copper ground plate. This may provide a more dynamic, self-renewing coupling to the pyramid's electromagnetic field than fixed soil grounding.
Dr Gerald Pollack's Exclusion Zone (EZ) water research shows water near hydrophilic/charged surfaces (like copper) forms an ordered, structured layer. A submerged copper plate beneath the pyramid may promote this structuring in a much larger volume than a land-based basin.
The floating platform is mechanically decoupled from the earth, damping ambient ground vibration. Combined with gentle wave motion, this may support a more stable meditative state for extended King's Chamber sessions.
A slack 4-point mooring lets the platform yaw freely with wind and current, meaning the structure naturally settles toward a low-energy orientation rather than being rigidly fixed — an experimental parallel to the pyramid's original alignment logic.
HDPE sealed pontoon floats
8×
Copper mesh pontoon wrap
~6 m²
Marine-grade aluminium deck frame
1 set
C110 copper tube 19mm OD (pyramid)
~12 m
Submerged copper ground disc 0.9m
1×
6 AWG copper wire (waterproof jacket)
3 m
Waterproof crystal housings
5×
Mooring lines + anchors
4×
Compass (for orientation checks)
1×